CLICK HERE FOR INDEX PAGE
 
THE PIN HAMMER AND CLAW HAMMER
V.Ryan © 2019
 
PDF FILE - CLICK HERE FOR PRINTABLE WORKSHEET
 
PIN HAMMER
 
A Pin Hammer is a light-wieght hammer, with a ‘thin head’, ideal for hammering panel pins in place. Panel pins tend to be very thin and when held in the hand, a slender hammer is needed. It is also a good selection for hammering tacks and small nails, which are difficult to hold in the hand.

 

 
 
 
The pin hammer is being used to ‘tap’ panel pins in place, holding two pieces of pine together. Starting a panel pin is very difficult with other hammers. The ‘thinner’ pin hammer, makes it possible to hold the panel pin and to hit its small head. PVA will also be applied to the joint. This is a simple way of joining natural wood.
 
 
 
 
CLAW HAMMER
 

This is a general hammer, preferred by those working in wood. Ideal for hammering nails, with the claw being designed to remove nails from wood. Hickory or ash is used for the handle, as it absorbs shocks and vibration, caused by the hammering process. Some versions of this hammer have metal handles, with rubber grips.

One use of this hammer is the removal of nails, using the ‘claw’ as a lever (see below).

 
 
 
 

This is a general hammer, preferred by those working in wood. Ideal for hammering nails, with the claw being designed to remove nails from wood. Hickory or ash is used for the handle, as it absorbs shocks and vibration, caused by the hammering process. Some versions of this hammer have metal handles, with rubber grips.

One use of this hammer is the removal of nails, using the ‘claw’ as a lever (see below).

 
 
CLICK HERE FOR EQUIPMENT AND PROCESSES INDEX PAGE
 
Google
 
Web www.technologystudent.com