SELLOTAPE HOLDER / CUTTER
V. Ryan © 2005
The animation opposite shows a sellotape dispenser, the type often seen on a desk top or in n office. Its operation is simple, the sellotape is pulled off the roll and is cut to the required length by stretching it over the steel cutter. Three views of a sellotape dispenser / cutter are seen below. |
|
|
|
Diagram ‘A’ is a side view and the role of sellotape and serrated steel cutter are clearly seen. |
|
|
|
Diagram ‘B’ is a plan view and shows the basic assembly of the plastic dispenser. The sellotape is ready to be pushed on to the roll holder. It is held in position by a ‘plug’. The plug is pushed into the roll holder, which is hollow and stays in position due to its tight fit. The steel cutter is ready to be pushed into a slot at the far end of the dispenser. |
|
|
|
Diagram ‘C’ gives an angled view of the sellotape dispenser. This may give clues as to how the main plastic part is manufactured. |
|
1. Name a plastic that is suitable for the manufacture of the sellotape dispenser. |
|
2. Name the manufacturing process that could be used to manufacture the dispenser. | |
3. With the aid of a diagram, describe the process you have named as your answer to question 2. |
|
|
|