| PDF FILE - CLICK HERE FOR PRINTABLE WORKSHEET | |
| Three dimensional drawing / sketching can be very difficult. However, using isometric paper, helps when drawing products that are often best explained, if drawn in 3D. | |
 |
|
 |
Near the bottom of isometric paper, draw three lines, which mark the bottom corner of the packaging. |
|
|
Complete the two sides of the packaging, following the isometric grid. |
 |
Sketch in the top of the ‘cuboid’. |
 |
Sketch the top sides. This will mean not following the isometric grid. The grid can be used to ensure that the ‘curves’ are centrally located. |
 |
Add the supporting piece, following the isometric grid. |
 |
Add the hand hole. This will allow the packaging to be held securely by hand. |
 |
Sketch in the holes, which will eventually hold the drinks bottles in position. |
 |
Sketch in the graphics, images and symbols. |
 |
Add appropriate colour and shade. Consider varying the ‘darkness’ of shade applied to each side. The horizontal sides could be shaded darker, than those that are vertical. |
| CLICK HERE FOR PRODUCT DESIGN INDEX PAGE | |